If your 2007 Saturn Aura is experiencing a problem with its brake pads, it’s important to replace them as soon as possible in order to avoid any accidents.
There are some simple steps that you can take in order to change the brake pads on your vehicle: Park the car safely and turn off all of the engine power Open both front doors and remove both of the rear wheels.
Remove the four bolts securing each brake pad (the same ones used when replacing brakes or rotors).
Raise each brake pad up until it clears its caliper piston, then lower it back into place onto its mounting bracket Replace bolt caps and tighten using a torque wrench to specifications specified by your manufacturer.
Contents
Brake Pads on a 2007 Saturn Aura
If you’re braking for a stop, be sure to have the appropriate pads on your 2007 Saturn Aura. The brakes require pressure in order to work properly and should not be tampered with or overused without proper brake pads installed.
Always use the front and rear brakes when stopping – they are meant for different purposes. Make sure that you replace your brake pads at least every 4 years, depending on how often you drive your car (and how much abuse it takes).
Keep your Saturn in good condition by regularly checking fluid levels, changing the air filter, and replacing spark plugs. If something does go wrong with your car’s braking system, don’t hesitate to bring it in to a mechanic for service as soon as possible.
If your 2007 Saturn Aura has less than 100,000 miles on it, its brake pads may need to be replaced. This is a relatively easy job for a professional mechanic and can cost around $100-$200 depending on the severity of the pad wear.
Many mechanics will also replace the rotors if needed as part of this repair process-this typically costs about $60-$80 per wheel.
Always have your car examined by a qualified mechanic before making any major repairs.
In most cases, replacing brake pads and rotors will ensure that you prevent further damage to your vehicle and keep you safe on the roadways
How To Change Brake Pads on a 2007 Saturn Aura
If your 2007 Saturn Aura is having trouble stopping, it may be time to change the brake pads. This guide will show you how to do it step by step.
Locate the Brakes
To change brake pads, you first need to locate them. On a 2007 Saturn Aura, the brakes are located on either side of the car in front and behind the wheel.
To find them, start by looking for two bolts that hold each brake pad in place. Remove these bolts using an Allen wrench and then carefully lift up each brake pad.
Be sure to keep track of which side goes where as you remove them so you can reinstall them correctly later on.
Disconnect battery cables
Before beginning any repairs or replacements on your car, it is always important to disconnect both of your battery cables as this will prevent potential damage from being done while working on your vehicle.
Remove the wheel
The first step in replacing your brake pads is to remove the wheels and suspension. This will make it easier to get to and work on the brakes.
Remove The Padlock and Allen Wrench
Next, use a lockpick or flathead screwdriver to unlock and remove the emergency brake cable clip (located just below).
Once this is removed, disconnect both hose clamps from each reservoir (one clamp per side) using a standard hex wrench.
Disconnect The Hoses from The Reservoirs
Now it’s time to take off the old pads and discs. First, detach one hose clamp from each reservoir (using your hex wrench), then slowly twist each hose until it comes free from its connector at the back of the reservoir.
Be careful not to kink or damage any hoses during this process.
Remove The Brake Pads and Discs
Next, gently pull off both old pads and discs—be sure to note which side goes where again before putting them away.
Finally reattach one hose clamp from each reservoir (using your hex wrench), being careful not to kink or damage any hoses in between. You’re now ready to install new pads and discs.
After taking off both of your front Wheels, remove either side’s Brake Pad & Disc Rotor Assembly (usually identified by a yellow star).
You may need a socket or ratchet set for this job depending on what type of screws hold it together – usually, there are 6 bolts holding everything in place (4 across from each other).
Once those bolts are removed, simply lift out everything as one unit – be careful not to lose any parts.
Install New Brake Pads
In order to replace your brakes on a 2007 Saturn Aura, you will first need to install new brake pads, the disc rotor assembly (which includes the hub and rotors), and finally the wheel.
This guide will walk you through each step in detail.
Why You Should Change Brake Pads on a 2007 Saturn Aura
Your 2007 Saturn Aura might be needing brake pads. There are many reasons why this could happen, but the most common is that the brakes wear down and don’t stop your car as well as they used to.
If you notice that your brakes aren’t stopping your car as well as they used to or if there’s a lot of noise when you apply the brakes, it’s time to replace them.
Decreased braking performance
Brake pads are one of the most common car parts that need to be replaced over time. When brake pads start to wear down, they lose their ability to stop your car quickly and smoothly.
Brake pad replacement is a relatively simple job that can often be done yourself without any specialized tools or knowledge.
Increased noise and vibration
When your brakes start to wear down, the metal on metal contact will produce more noise and vibrations than normal.
This issue will become increasingly apparent as the brake pads get older and worse, leading to an increase in overall aerodynamic drag on your vehicle.
Poor stopping distance
The effectiveness of a given set of brakes depends greatly on how well they stop your car quickly from a given distance.
As brake pads wear down, they may not be able to provide enough resistance for you to reach safe braking distances in time situations.
FAQs
How Much Are Brake Pads for a Saturn Aura?
The average cost for brake pads for a Saturn Aura is between $209 and $232.
How Much Are Rotors for a Saturn Ion?
The rotors for a Saturn Ion are typically priced at around $62.99 and a little more.
How Long Do Acura Brakes Last?
Acura brakes last anywhere from 30,000 – 60,000 miles depending on driving habits.
Is it easy to replace brake pads?
Replacing brake pads is usually easy, but some vehicles may require special tools or instructions.
How To Change Brake Pads on Jeep Patriot
To change brake pads on a Jeep Patriot,
- First remove the wheel.
- Then remove the two bolts that hold the brake caliper to the brake rotor.
- Next, remove the brake caliper.
- Finally, remove the old brake pads and install the new ones.
To Recap
If your 2007 Saturn Aura is having trouble slowing down, it might be time to replace the brake pads. The process of changing a pad is not difficult, but it does require some tools and knowledge about car mechanics
Remove two screws that hold in each caliper Grasp both sides of each rotor (they should have yellow tabs), and pull them off from either side of the hub.
Carefully place new brake pads onto rotors; make sure they are properly seated before replacing screws and covers.
Be aware that there may be other issues with your vehicle that need attention at this time- please consult a mechanic if you experience any difficulties following these simple instructions.