Brake pads are an important part of your car’s safety and should be changed at least once per year, or when the brake fluid is low.
The Honda Civic has two types of brake pads- friction material and a disintegrating compound pad.
Friction material pads wear quickly with use, so it’s important to change them as soon as you notice they’re wearing down significantly (about every 6 months).
Disintegrating compound pads don’t wear down easily but do need to be replaced more frequently than the friction material type because they can become contaminated with rust over time.
Changing your brake pads will result in improved braking performance and longer life for your brakes overall.
Contents
Brake Pads on 2007 Honda Civic
If you have a 2007 Honda Civic, be sure to check your brake pads regularly to make sure they are in good condition and working properly.
Brake pads should last for around 50,000 miles or four years on average if used regularly and maintained correctly.
And if you’re not sure when your brakes need to be replaced, take them to an auto mechanic for inspection and recommendation.
When shopping for brake pads, make sure they are available in a variety of colors so you can find the right one for your car.
When your brake pads start to show signs of wear or tear, it is time to replace them before they cause any accidents or damage to your car.
You can purchase new brake pad sets directly from the manufacturer or at a local automotive store depending on the make and model of your car.
Check with your mechanic prior to installing new brake pads so that everything is aligned properly and there are no problems after installation occurs.
Tools Required to Change Brake Pads on 2007 Honda Civic
If you’re looking to replace your brake pads on a 2007 Honda Civic, you’ll need the following tools: a wrench, socket set, ratchet, and extension cord.
First, make sure that your car is parked on level ground. Next, remove the four screws that hold the front of the brake pad in place.
Once those are out, use the wrench to loosen each screw one at a time and lift off the old brake pads.
Replace them with new ones and tighten all four screws back into place using the ratchet and extension cord.
- New Brake Pads
- Rotor can
- Jack
- Lug nut wrench or socket (1/2″ to 3/4″)
- Wrench for adjusting the brake pads (if applicable) 6. Socket extension 7.” Channel-lock pliers
- Crescent-wrench
How To Change Brake Pads on 2007 Honda Civic
If you’re having trouble braking in your 2007 Honda Civic, it might be time to replace the brake pads.
Brake pads are sacrificial discs that wear down with use, so it’s important to change them at least every three months or when they start showing signs of wear.
Locate the Brake Hose
The brake hose can be located on either side of the car, behind or in front of the axle. It is typically a black plastic tube with a blue and white stripe running along with it.
Remove The Brake Pad Holder & Spring
On most Honda Civics, there are two screws that hold down the pad holder and spring – remove them using a Phillips head screwdriver. Be sure to set these items aside in case you need them later on.
Disconnect The Brake Lines from The Reservoirs (Brake Calipers)
Locate two small clip-on hoses which connect each reservoir to one line coming from the master cylinder – disconnect both lines by squeezing them together until they pop off (be careful not to pinch yourself).
Release The Grips on Each Side Of The Pad
On older Hondas, you will need to release the grips on each side of your new pads with a hammer or rubber mallet before installing them onto the caliper disc. Do not damage your caliper discs while doing this.
You’ll also want to make sure that all four corners of each pad are seated properly against the rotor – if they’re not aligned correctly, your brakes will feel mushy when applied…or worse yet, fail completely.
Align New Pads onto Calipers and Fit Springs into Position
With new pads installed, it’s time to fit those springs into position within their holders and reattach both brake lines at reservoirs once again – do NOT forget about those pesky clip-on.
FAQs
How Much Does It Cost to Replace Brakes on a Honda Civic?
The cost to replace brake pads and rotors on a Honda Civic would range from $150 per axle to $300 per axle.
How Often Do You Change Brake Pads on Honda Civic?
Brake pads should be replaced every 40,000 to 50,000 miles or every three years, whichever comes first.
Do You Need to Grease Brake Pads?
Brake pads protect the brake system of your car. A clean & frictionless brake pad is crucial to reduce braking force, increase safety, and reduce noise.
Can You Spray WD40 on Brake Pads?
You cannot use WD40 on brake pads that can cause damage to the surface of brake pads because it will stick to them and leave them pitted and worn out.
Do You Need to Open Brake Fluid Reservoir When Changing Brakes?
If you need to change the brake fluid, you will have to open the brake fluid reservoir.
To Recap
Brake pads are an important part of your car, and it is important to change them regularly. If you notice any signs of wear or tear on your brake pads, it is time to replace them as soon as possible. Driving with worn brake pads is bad.
Changing the brake pads will not only improve stopping power but also prolong the life of your brakes overall.
There are a variety of tools that you can use to change the brake pad on your 2007 Honda Civic- making the task easier than ever before.
Follow these simple steps, and you will be able to change your brake pads without any trouble at all.